Ardu-chute. 433mhz wireless ardu parachute
$30-250 USD
货到付款
I want to make a R/C parachute system for my rc plane.
Currently I have an arduino uno which has a push button on input A0 and this board sends out a serial value over a 433mhz tx from digital pin 2
I am recieving ok as watching the nano on the serial monitor
it sees the change from 0 to 1023 when I press and hold the button down for a little bit
I am very new to Arduino and have reached my current limits. So I seek your services and skills for what I would like to achieve below.
UNO- is transmitter end. I want sketch which will only transmit a character command "popchute" once a push button has been pressed, I want a LED output to go LOW when the button is pressed.
NANO- receiver end I want this to have 2 inputs as well as the recieved character command.
input 1- push switch once pressed arms parachute system and will allow output IF
input 2- is released (unpushed) (this happens once drone takes off/switch not making contact with the ground)
If command is received and inputs 1 has been armed and input 2 has gone low I want 2 output pins made high.
I hope this helps you see my vision?
I have used the virtual wire library and these modules- http://www.hobbycomponents.com/index.php?route=product/product&path=93&product_id=229
项目ID: #4511994
关于项目
授予:
I am currently working on my quadrotor, and have a good idea about these systems. Please check your pm for more details.
有3名威客正在参与此工作的竞标,均价$90/小时
Dear Sir, We are Reserach and Development company whose working area are : -Digital Motor Control -Analog Design -Electronic Design -Power Electronics -PCB design -Embedded system -Matlab -Simulation of ha 更多
Quite straight forward, happy to help. First thing I'd need is details of your wireless system.