Design PCI device + FPGA PCI core

已取消 已发布的 Dec 10, 2007 货到付款
已取消 货到付款

I need a custom PCI module with the following requirements:

1) PCI interface is based on FPGA

2) FPGA PCI-target core is FREE of license

3) FPGA has SPI-master core

4) FPGA has TDM interface

5) FPGA with lowest price is required!

6) PCI device must have usual interface for OS (Linux in most) - BAR, DevID, VendorID etc

7) PCI device must have 3-5V interface

The structure of the PCI-card is a follows:

FPGA <-> Infineon DuSlic-SP chip

8 wires are the interface to DuSLIC:

a) 4 wires for SPI (CS, CLK, TX, RX)

b) 4 wired for TDM (FS, CLK, TX, RX)

Altera or Xilinx FPGAs are preferred, but not required. The lowest price is the main feature. No schematic for DuSLIC is in this project. Only PCI card + some connector for 8 wires. The PCB design for the card is not required. Schematic + FPGA core is required. The project is approved after a prototyping.

电子

项目ID: #203136

关于项目

8个方案 远程项目 活跃的Jan 12, 2008

有8名威客正在参与此工作的竞标,均价$1069/小时

botondkirei

Hello! My name is Kirei Botond, I am a PhD student at the Technical University from Cluj Napoca, Romania. My area of expertize is FPGA bazed digital design. I am very familiar with Xilinx FPGAs and the design enviro 更多

$1500 USD 在50天内
(3条评论)
3.8
rwender

Hello, I'm an ASIC/FPGA designer (Verilog-preference) with over 20 years experience in ASIC/FPGA design. I'm a Xilinx design expert and I've successfully created PCI 32/64-bit 33 and 66 MHz designs for both ASICs and 更多

$1250 USD 在27天内
(0条评论)
0.0
pcbbackoffice

Dear Project Owner, We are in to embedded solutions since 1999 having 60 engineers working on this. We have already develop this type of application and also would like to develop for you. we have good experience 更多

$1200 USD 在30天内
(0条评论)
0.0
galileng

[removed url]

$1500 USD 在30天内
(0条评论)
0.0
pl3t3

please view pm

$650 USD 在15天内
(0条评论)
0.0
asim569

Please not down that Icant proveid any hardware/prototype. I can only provide design/codes etc

$700 USD 在15天内
(0条评论)
0.0
robertmaslov

PCI expert here. Let me do it for you. Please check PM. No problem at all. We can start asap!

$350 USD 在10天内
(0条评论)
0.0