PCB Print
Specs:
• Input voltage between 10-30V, with polarity protection.
• 4x 3mm mounting holes in the corner.
• Make the park button also ready for 10-30V enable. (From ignition key).
• 5 Pin plug, to external switch panel (Cal, Park, Left and Right).
• 4 pin plug, to hall sensor(GND, 5V, hall1, and hall 2)
• 3 pin plug, To Actuator Pot sens (GND, 5V and signal).
• 4 pin header. To BTS7960. (GND, 5V, PWML and PWMR).
• General EMC decupling of PCB.
• General EMC Decupling of driver and micro controller.
Hello,
I can help you build you design to your required specification
I can also help you find a cheap and good PCB supplier for producing the PCB at the end
I will like to have a meeting and so you can tell me more about the design
About me:
I have 8 years of product design in the automotive industry. I am an expert in:
- Dc - Dc converters
- DDRAM memory's simulation and layout
- USB charging - accelerometers , gyroscopes
- GPS and GSM - LCD Displays
- LED power calculation
As a Layouter I have 5 Years experience. I am an expert in
: - Power Dissipation Calculation
- EMC Rules - Impedance Calculation
- Manufacturing Rules I have made Layout for ARM processor. Work also with BGA footprint. I have done projects even on 10 layer. So I know how to build a layer stack up.
As Layout and Schematic software I am an expert in Eagle, PADs, Zuken.
As Simulation software for the Schematic I used LTSpice.
Thank you for your time,
Have a NIce Day,
Alex.
I have experience designing pcb. the circuit you want to do is very simple by what I see, if you can provide more information would appreciate to see if I can reduce design time