CAD project of existing machine

Hi Freelancers, I need a technical drawing of an old simple machine, with every part breakdown so they can be given to potential manufacturers, with some working 3D simulation This would an ideal for someone based in UK, but not limited to. I do not discriminate, but I bet loads of question would be raised and if I showed this someone the concept would be more easily understood. Can show the unit within UK. I've got an old machine, almost complete, the rest might be available as pictures. So, general concept of it is as follows: * machine must operate off regular 220-240V mains. Max. power consumption 13Amp, ideally below 3,5kW * water tank with immersion switch with a small pipe to let the steam away and spread along the entire width of heating plate * heating element(s) attached to the heating plate. Entire surface of this plate must be able to get equally hot. Thermal range 0-220 C adjustable. * mechanically simple - 2 motors, a few switches and cogs, activate 1 motor moving down and stopping heating plate in position where it puts decent pressure on the roll. Once reached its target point 2nd motor starts the roll still being pressed on . * roll width ideally around or just over 1m but flexible if there're constrains of technical nature, with about 15cm diameter. * must be able to fold down, as per picture, keeping balance if used on leg stand and / or be easily detached off the leg if someone wanted to use on a worktop. with some gap kept . * safe to use - from both electrical perspective as well as mechanical and some finger guarding element in front would be helpful *