关闭

Design of an Elevator Control Mechanism for Small Airplane

该项目收到27 来自天才威客的竞标,平均竞标价格为$251 USD

为像这样的项目获取免费报价
雇主工作
项目预算
$40 - $70 USD
全部竞标
27
项目描述

REFER TO THE ATTACHED FILES

Design of an Elevator Control Mechanism for a Small Airplane

You are asked to design a control mechanism for the elevator of a small single engine airplane, shown to scale in Figure 1. For an airplane to gain or to lose altitude in normal operating conditions, it is necessary that the pilot control the pitch motion of the airplane by changing the angle that the elevator in the tail section makes with respect to the horizontal. For this purpose, the pilot must push or pull a stick placed in front of him/her. The control mechanism that you are asked to design will transmit the motion of the stick to the elevator. When the pilot pullsthe stick, the elevator must move up in order for the airplane to pitch up and to gain altitude. When the stick is pushed, the elevator must move downward in order for the airplane to pitch down and to lose altitude. The range of motion of the pilot's arm should preferably be within 180 degrees from the horizontal x-direction for push to -120 degrees for pull (refer to Figure 2). The motion of the stick must cause the elevator to rotate -20 degrees and +20 degrees from the horizontal direction (refer to Figure 2). Note that there are areas of the airplane that are reserved for passengers, fuel tank, etc. which cannot be used for placement of the mechanism. The available space for placing the control mechanism is shown in Figure 2 as the shaded area. The drawing is to scale so that you can measure all the necessary dimensions. All the motion of the designed mechanism must be within this area. You are not allowed to use belts, chains, cables, nor pulleys.

在寻找赚取金钱的机会?

  • 设定您的预算和时间框架
  • 大致描述您的建议方案
  • 为您的工作领取工资

雇用同样在该项目上竞标的威客

    • Forbes
    • The New York Times
    • Time
    • Wall Street Journal
    • Times Online