Neopixel Arduino Clock with RTC, LDR and pushbutton inputs

INTRODUCTION Hi everyone. I am making a clock that tells the time in words. The arduino code is basically done however I just need some help :) The clock runs off neopixels connected in 14 strips of 14 neopixels. The neopixel data is then run off an Arduino Uno. There are also 4x inputs into the arduino, those being: 1) An LDR sensor to change the intensity of the neopixels depending if the conditions are light or dark 2) An RTC to keep more accurate time of the clock than the onboard clock on the Arduino 3) 2x pushbuttons - one for adding 1x minute to the time and one for adding 1x hour to the time. To get an idea of what the project looks like, the clock is similar in design and look to : [login to view URL] But instead of individual LEDs, shiftregisters, microcontrollers, I'm using neopixel strips and the Arduino Uno instead to make it easier. WHAT THE FREELANCER MUST BE KNOWLEDGEABLE IN Must know Arduino code for Neopixels Must also know how to add code for an RTC, LDR and 2x pushbutton inputs The inputs for the arduino are as follows: 1) An RTC to keep track of time accurately (DS3231 AT24C32 IIC I2C) 2) An LDR to sense light and change the brightness of the Neopixels (This one: [login to view URL]) 2) 2x pushbuttons, one to increase the time by one minute and the other to increase time by one hour(These ones: [login to view URL]) I already have Arduino code for the clock however I have doubts whether the code is working 100% correctly. THINGS THE FREELANCER WOULD NEED TO DO 1) Check the entire code for bugs, make sure syntax is correct, everything looks okay 2) Add the code for the pushbuttons 3) In regards to the RTC, I am not sure if the code correctly uses the RTC time to keep track of time or whether the onboard timepiece on the arduino is being used so this will have to be checked 4) In regards to the LDR, I am not sure if this has been coded backwards (as in more LDR light will make the LED's darker and less light will make them brighter which is the opposite of what I require). WHAT I HAVE CURRENTLY DONE The LED's are working but the code is not. The code is basically done, it just needs to be fixed. The current connections I have on the Arduino are as follows: CURRENT CONNECTIONS Neopixels Arduino PIN 5V power = 5V Data/DIN = 3 GND = GND LDR Arduino PIN Out = 13 VCC = 5V Gnd = GND RTC (DS3231 AT24C32) Arduino PIN SLC = A5 SDA = A4 VCC = 5V Gnd = GND Push button 1 Arduino PIN Leg 1 = Not connected Leg 2 = Not connected leg + = Not connected Leg - = Not connected Push button 2 Arduino PIN Leg 1 = Not connected Leg 2 = Not connected Leg + = Not connected Leg - = Not connected Any other questions, please feel free to ask. Cheers, Robert