Looking for someone to help me get klipper installed on my Ender s1

$30-250 USD

已关闭

已发布

大约 2 年前

$30-250 USD

货到付款

Your printer's firmware reported an error. Due to that OctoPrint will disconnect. Reported error: Shutdown due to M112 command when trying to flash klipper Ive tried -Disconnecting octoprint -formating hard drive -flashing marlin and reflashing klipper - changing file name

3D Printing

Raspberry Pi

项目 ID: 33442703

关于此项目

3提案

远程项目

活跃2 年前

想赚点钱吗？

电子邮箱地址

在Freelancer上竞价的好处

设定您的预算和时间范围

为您的工作获得报酬

简要概述您的提案

免费注册和竞标工作

3威客以平均价$250 USD来参与此工作竞价

@engrhassanwali

Hi! I have understood your requirements about your project with every detail of it. I am an Electrical Engineer with more then 9 years experience in electronics, circuit design, PCB layout, Verilog, FPGA, Embedded System, microcontrollers, Proteus, Arduino, ESP32, Raspberry pi, NB-IOT, Algorithm and Product design. I can assure satisfactory work. I'll be glad to work with you. Thank You!

$250 USD 在7天之内

2.2

(3条评论)

3.0

@amilmef

Hi. I am Amil. I have more than 5 years experince in 3D printing and servicing for 3D printers. Just message me please and let's solve your concerns. Kind regards.

$350 USD 在7天之内