Face module M1

Create demo on dev board. Module will be used for security of objects like car. Car will start when face is recognized. When face is not recognized then the driver can decide to use NFC card. The module has 3 state modus: - Standby - Pre-Active - Active - Alarm - UPDATE STANDBY: - Sending each 5min position, temp and time to API. And API will check if there is update information and give this back to module. If there is update information than go to UPDATE modus. - Will go modus alarm when the car is driving - Will go modus alarm when the car is moving - Close all Relays PRE-ACTIVE: - Send message to API that the STATE is changed. - Camera will detect face and take picture. Send this to API. When face is recognized that the module get ok. - NFC will ready to read card - If there is nothing happening for 5 minutes that the module will be go to STANDBY modus. - Will go modus alarm when the car is driving - Will go modus alarm when the car is moving - Close all Relays ACTIVE: - It’s possible to start because relays are open - If the car is not driving the timer will be activated. After 5min of inactivity the module will be to modes PRE-ACTIVE. - Send every 1 minute position, temp - Open all Relays ALARM - Set siren on - Send every 1 minute message to API - Close all Relays UPDATE - Will send request to server and get update info back. - Update NFC (Create or delete card) - Update firmware Freelancer will buy all parts and modules that is needed